Speed Dial Memory; Store A Number/Name In Memory - VTech Cordless Telephone Manual

Speed Dial Memory

You can store up to nine telephone numbers with names (up to 15 characters and 24
digits in each location) into the speed dial memory locations you assign (1 through 9) in
each handset. You can also store telephone numbers with names alphabetically in the
directory. See Telephone Directory for instructions.
NOTES:
•
The entries you stored in speed dial memory will be marked with 01 through 09 in the
telephone directory.
•
Press (off) at any time to exit memory dial mode.

Store a Number/Name in Memory:

1. Press PROG on the handset.
2. Press or until the screen displays SPEED DIAL.
3. Press SELECT. The screen displays ENTER 1-9.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone sounds,
and you cannot store a new number until you delete a record in speed dial memory or
telephone directory.
4. Press the key (1 through 9) for the memory location where you're storing this entry, if
the selected location is empty, the screen displays ENTER NAME.
NOTE: If the location is not empty, your new entry will be stored in place of the old and the
first entry will be deleted. Take caution to not save over entries you do not wish to delete
from memory.
5. Using the chart below, enter up to 15 characters for the name you're storing with the
number. Use to backspace and make corrections; use
space.
Dial Key
1:
2:
3:
4:
5:
6:
7:
8:
9:
0:
:
*
#:
Presses
1 2 3 4 5 6
1
A B C 2
D E F 3
G H I 4
J K L 5
M N O 6
P Q R S
T U V 8
W X Y Z
0
'
& , -
14
to advance and add a
7
9
. #