Setting The Alarm Clock; Using Multiple Handsets; Registering Handsets; Register Handset - Siemens Gigaset S810A User Manual

Setting the alarm clock

Setting the alarm clock
Prerequisite: The date and time have
¢
already been set (
Activating/deactivating and
setting the alarm clock
á
¢ ¢
v
Alarm Clock
¤
You can enter data in the following fields:
Activation:
Select On or Off.
Time:
Enter the wake-up time in 4-digit format.
Occurrence:
Select Daily or Monday-Friday.
Volume:
Set the volume (1–6).
Signal:
Select melody.
§Save§
Press the display key.
¼
In idle status, the
are displayed.
A wake-up call is signalled on the display
and with the selected ringtone (
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
While the wake-up call sounds, you can
permanently change the volume by press-
ing the side keys ø (louder) or ÷ (quieter).
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
62
page 18).
icon and wake-up time
¢
page 4).
or
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.

Using multiple handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset S810H handset can be registered
on up to four bases.
Manually registering a
Gigaset S810H to a Gigaset S810/
S810A
You must activate manual registration of the
handset on both the handset (1) and the
base (2).
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display e.g., INT 1. If not, repeat
the procedure. .
1) On the handset
The handset is not registered to a base.
§Register§
Press the display key.
The handset is already registered to a base:
Ï
¢ ¢
v
Registration
¢

Register Handset

If the handset is already registered to four
bases:
s
Select base, e.g., Base 3 and
§OK§
press
~
If required, enter the system
PIN for the base and press
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
.
§OK§
.