External View - Toshiba RAV-SM561CT-E Service Manual

External view

Strictly comply with the following rules to prevent damage of the indoor units and human injury.
• Do not put a heavy article on the indoor unit. (Even units are packaged)
• Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, be
sure to use buffering cloth, etc. to not damage the unit.
• Do not apply force to the other parts (refrigerant pipe, drain pan, foamed parts, or resin parts, etc.).
• Carry the package by two or more persons, and do not bundle it with PP band at positions other than
specified.
Upper pipe draw-out port (Knockout hole)
Power supply cable take-in port (Knockout)
128
Remote controller cable take- in port
84 (Knockout hole)
Left drain size
B (Hanging position)
Refrigerant pipe (Gas side ØD)
Hanging bolt
Ceiling surface
Unit
Considering pipe/wire connecting work inside the ceiling after the indoor unit has been hanged, select an installation
place and determine piping direction.
• If the ceiling has already been set before hanging the main unit, prepare refrigerant pipe, drain pipe, indoor
connecting wire, remote controller cord, etc. up to the place where pipe and wire can be connected.
• Check the size of the indoor unit, and match the indoor unit size using the attached installation pattern.
How to use attached installation pattern
Using the pattern, positioning of the hanging bolt
and pipe hole can be performed.
* As an error to some degree may generate on the
pattern size due to temperature and humidity, be
sure to confirm the size.
REQUIREMENT
216
110 76
Refrigerant pipe
(Liquid side ØC)
75
146
A
210
Pipe draw-out port (Knockout hole)
167
Drain port VP20
105 (Inner dia. Ø26, hose attached)
Drain pipe connecting port
97
Remote controller cable take- in port
Power supply cable take-in port (Knockout hole)
347
262
135
Outside air take-in port
(Duct sold separately)(Knockout hole Ø92)
Pipe hole on wall (Ø100 hole)
Model name
Wireless sensor
561CT
mounting section
801CT
1101CT to 1401CT
Installation
pattern
23
Remote controller cable take- in port
(Knockout hole)
Drain left pipe draw-out port (Knockout hole)
A B C
910 855 Ø6.4
1180 1125
Ø9.5
1595 1540
Ceiling surface
Wall face
84
D
Ø12.7
Ø15.9