Program Delay - Smeg Dishwasher Instruction Manual

User instructions

PROGRAM DELAY

The PROGRAM DELAY
washing program by from 1 to 12/24 hours depending on the model. This
option allows the dishwasher to be operated at the time of day of the user's
choice. The first time the PROGRAM DELAY
option light comes on and 1:h appears on the DISPLAY. The button can
then be pressed again, to set the delay required (
button is pressed for a few seconds, the DISPLAY shows the time left (time
remaining) to the end of the selected program (e.g.
washing cycle + program delay). When the user confirms the program start
(read the relative section) a prewash will be carried out, after which the
PROGRAM DELAY set will begin, and the time remaining on the DISPLAY
will gradually be counted down. At the end of the delay set, the option light
goes out and the washing cycle starts.
N.B.: It is not possible to select the PROGRAM DELAY option once the
cycle has begun.
Chosen the delay, proceed with the program start, press the button
START/PAUSE
start to flash.
The machine will perform a dish pre-washing, and when finish, the "delay
program" will enter in function as it was first set.
In case you want to put to zero the "delay program" within the running
program it is necessary:
to press the START/PAUSE
START/PAUSE (D) symbol remain lid up on the display;
to press the DELAY PROGRAM
delay program (START/PAUSE symbol shut off);
to press the START/PAUSE
N.B.: It is not possible to select the "delay program" when the program
have already began.
button can be pressed to delay the start of the
for same seconds until the START/PAUSE symbol
button for some seconds until the
button to make start the program.
button is pressed the
2:h, 3:h
, ... etc.). If no
5:40
, duration of the
more times until the reset of the
17