Direct Set-Up
To set up the ZAPPER for your Television, Video and Satellite Receiver (or
Cable Converter) follow the instructions below. To set up your Television:
1
2
TV
3
4
Volume +
Volume -
5
6
7
6
Setting Up The ZAPPER
Find your Television code in the Set-Up Code section (page
66-80). Codes are listed by brand name. The most popular
codes are listed first. Make sure that your Television is
switched on (not in standby).
Press and release the TV key to select the device.
Press and hold down MAGIC until the red light blinks
twice (it will blink once then twice).
Enter your 5-digit code according to the chart below.
The red light will blink twice.
=
1
=
2
Now, aim the ZAPPER at your Television and press
POWER. If your Television switches off, your ZAPPER
should be ready to operate your device.
Turn your device back on and try all the remote's functi-
ons to ensure they are working properly. If the functions
do not work properly, repeat steps 1-6 using another code
listed under your brand.
Write the codes for your TV, VCR and SAT in the
boxes provided on page 7 and inside the battery
compartment for easy future reference.
Programme +
Programme -
WWW.ONEFORALL.COM
=
3
=
4