Changing Engine Oil - Yamaha F9.9D Ower's Manual

Maintenance
or other qualified mechanic.
2. Verify whether the idle speed is set to
specification. For idle speed specifica-
tions, see page 40.
EMU29093

Changing engine oil

EWM00760
WARNING
Avoid draining the engine oil immedi-
G
ately after stopping the engine. The oil
is hot and should be handled with care
to avoid burns.
Be sure the outboard motor is securely
G
fastened to the transom or a stable
stand.
ECM01240
CAUTION:
Change the engine oil after the first 10
hours of operation, and every 100 hours
or at 6-month intervals thereafter. Other-
wise the engine will wear quickly.
NOTE:
Change the engine oil when the oil is still
warm.
1. Put the outboard motor in an upright po-
sition (not tilted).
2. Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Loosen and remove the drain screw
51
while holding the container under the
drain hole. Then remove the oil filler cap.
Let the oil drain completely. Wipe up any
spilled oil immediately.
1. Drain screw
Drain screw tightening torque:
8.0 Nm (5.9 ft-lb) (0.82 kgf-m)
3. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
NOTE:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten
the drain screw to the correct torque with a
torque wrench as soon as possible.
4. Add the correct amount of oil through the
filler hole. Install the filler cap.
Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity (excluding oil filter):
ZMU04416
1.0 L (1.06 US qt) (0.88 Imp.qt)
ECM00970
CAUTION:
Do not overfill the oil, and be sure the
G
1
ZMU04417