Table of Contents
Advertisement
NOTE:
When the engine is cold, it needs to be
G
warmed up. For further information, see
page 30.
If the engine is warm and fails to start,
G
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 61.
EMU27600
Electric start/prime start models
1.
Place the gear shift lever in neutral.
NOTE:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2.
Attach the engine stop switch lanyard to
a secure place on your clothing, or your
arm or leg. Then install the lock plate on
the other end of the lanyard into the en-
gine stop switch.
EWM00120
WARNING
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
your arm or leg while operating.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
Avoid accidentally pulling the lanyard
G
N
ZMU04384
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
boat to be thrown forward.
3.
Place the throttle grip in the "
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
4.
Push the starter button to start the en-
gine.
Operation
ZMU04385
"
ZMU04386
28
Advertisement
Table of Contents
