Adaptation To Different Types Of Gas; Replacing The Hob Nozzles; Replacing The Bottom Burner's Nozzle; Arrangement Of Burners - Smeg Oven Instructions For Use Manual

12. ADAPTATION TO DIFFERENT TYPES OF GAS

BEFORE PERFORMING ANY OPERATIONS, SWITCH OFF THE POWER SUPPLY TO THE
APPLIANCE.
Appliance set for gas:
In the case of operation with other types of gas, the burner nozzles must be changed and the minimum
flame adjusted on the gas taps.
To change the nozzles, proceed as described in the following paragraphs.

12.1 Replacing the hob nozzles

1 Remove the pan stands, all burner caps and flame-spreader crowns to
access the burner casings.
2 Unscrew the nozzles using a 7 mm socket wrench.
3 Replace the burner nozzles according to the type of gas to be used (see
12.4 Burner and nozzle characteristics table).
4 Replace the burners in the correct position.

12.2 Replacing the bottom burner's nozzle

1 Remove all accessories from inside the oven
(such as trays, racks etc.).
2 Lift up the oven base and pull it outwards as
shown in the figure.
3 Unscrew the fastening screws A and B
completely.
4 Move away the lock that secures the
thermocouple and igniter fastened by screw
A.
5 Slide the burner outwards until the nozzle is
accessible.
6 Using a 7 mm socket wrench, replace the
nozzle, inserting a new nozzle suitable for the
type of gas to be used (see "12.4 Burner and
nozzle characteristics table").

12.3 Arrangement of burners

Instructions for the installer
Natural gas at a pressure of 1.0 kPa (see label on product)
Burner
Auxiliary
Semi-rapid
Rapid
Wok
EN
27