Table of Contents
Advertisement
System connections (continued)
CD-MPX870H
ENGLISH
Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM
75 OHMS socket and position the FM
aerial wire in the direction where the
strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM
and GND terminals. Position the AM
loop aerial for optimum reception.
Place the AM loop aerial on a shelf,
etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling >
Speaker connection
Connect the black wire to the FRONT SPEAKERS minus (-) terminal,
and the red wire to the FRONT SPEAKERS plus (+) terminal.
E-7
Speaker Light-Up connection
Connect the speaker light-up wires to the SPEAKERS LIGHT-UP
sockets for speaker illumination. To turn off the speaker light-up fea-
AM loop
FM
ture, press the CLEAR/DIMMER button on the remote control for 2
aerial
aerial
seconds or more.
ANTENNA
FM
GND
AM
75 OHMS
Note:
Placing the right speaker light-up wire to the RIGHT socket and the
left speaker light-up wire to the LEFT socket.
Caution:
Use speakers with an impedance of 6 ohms
< Attaching to the wall >
or more, as lower impedance speakers can
damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Wall
Screws (not supplied)
Do not let the bare speaker wires touch
each other.
Do not stand or sit on the speakers. You may
be injured.
Do not allow any objects to fall into or to be
placed in the bass reflex duct.
Red
Black
03/12/17
LEFT SPEAKER
RIGHT SPEAKER
Incorrect
CD-MPX870 EN.fm
Advertisement
Table of Contents
