Table of Contents
Advertisement
Using the 500-sheet
Paper Deck and
Cassette
The optional 500-sheet Paper Deck and Cassette holds 500 sheets
of 20 lb (75 g/m2) paper. Refer to the section "Selecting Paper"
(page 4-2) for acceptable paper sizes and weights.
When installed, the 500-sheet Paper Deck and Cassette is accessed
as Tray 2. If two Decks are installed, the lower one is accessed as
Tray 3.
(See Appendix A of the System Administrator Guide for ordering
information and Appendix C of the System Administrator Guide for
installation instructions.)
•
Do not attempt to load the 500-sheet Paper Deck and
Cassette during printing.
•
Do not overfill the paper cassette.
If you are not changing paper size, go to Step 2.
1
Adjust the end and width guides to fit the size of paper you are
loading.
A
Lift up one side of the end guide (1) at the rear of the tray, then
lift up the other side of the end guide.
B
Pull out the tray to lengthen it, or push it in to shorten it.
C
Press both sides of the end guide down until it clicks into place
at the desired length.
D
Slide the width guide (2) to fit the width of the paper.
Load paper. Refer to Table 4.4 on page 4-14 for correct paper
2
orientation.
The type of paper loaded (plain, prepunched, letterhead,
transparency, etc.) must be set using the Tray 2 Type (or
Tray 3 Type) item in the Control Panel's Tray Menu (refer to
Chapter 3 of the System Administrator Guide).
Chapter 4: Paper Loading and Orientation
Loading Paper
4-13
Advertisement
Table of Contents
