Smeg Oven Instructions For The User page 60

9.5 What to do if...
The oven
completely off
The oven does not heat up •
The controls
respond.
The cooking
longer than those indicated
in the table.
After
"pyrolysis" cleaning cycle
(only on some models) it is
not possible to select a
function.
The display shows ERR 4
(on pyrolytic models only)
If the door is opened during
a fan-assisted function, the
fan stops.
If the problem has not been resolved or in the case of other types of fault,
contact your local technical support centre.
62
Instructions for the user
display is
do not
times are
the automatic
• Check the mains power supply.
• Check whether an omnipolar switch upstream
of the oven supply line is in the "ON" position.
Check whether it has been set in "showroom"
mode, for further details see "6.14 Secondary
menu".
• Check whether it has been set in "child lock"
mode, for further details see "6.14 Secondary
menu".
• Check whether it has been set in "PO" mode,
for further details see "6.14 Secondary menu".
• Verify whether the door locking device has
switched off. If it has not, the oven has a
protection device that does not allow functions
to be selected while the door locking device is
active. This is because the temperature inside
the oven is still too high to permit any type of
cooking.
• The door locking device has not properly
attached to the door. This might be because the
door was accidentally opened during its
activation. Switch off the oven and switch it on
again waiting a few minutes before selecting a
new cleaning cycle.
• This is not a fault. It is a normal operation of the
appliance, useful when cooking foods in order
to avoid excessive heat escaping. When the
door is closed, the oven will return to normal
operation.