Siemens Gigaset E360 User Manual page 8

For questions and problems see page 23.
Initial charging and discharging of
batteries
Battery charging is indicated in the top right
of the display by a flashing battery icon e,
V or U. During handset operation, the
battery icon indicates the charge status of
the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged discharged through use.
and
¤
To do this, leave the handset in the base
without interruption until the battery
icon stops flashing in the display (approx.
13h).
¤
Once the batteries are fully charged,
remove the handset from the base and
do not put it back again until the batter-
ies are fully discharged.
Note:
After the first battery charge and discharge you
may replace your handset in its base after every
call.
Please remember:
u
Always repeat the charging and discharg-
ing procedure if you remove the batteries
from the handset and re-insert them.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a time the charge capacity of the
batteries will decrease for technical rea-
sons.
Note:
You will find explanations for the symbols and
typographical conventions used in this user
guide in the appendix, page 23.
Setting the date and time
¢ ¢
§Menu§
Settings
¢
§OK§
~
Enter the day, month and year
with 6 digits and press
Use q to move between
the fields.
~
Enter hours and minutes with 4
digits (e.g. 0 7 1 5 for 07.15 hrs)
and press
between the fields.
Once the phone is registered and the time set,
the idle display looks as shown on page 1.
Your phone is now ready for use.
First steps
¢
§OK§
Date/Time
§OK§
.
. Use q to move
§OK§
7