Restoring The Base Station To; Factory Settings; Operating The Base Station; On The Pabx - Siemens Gigaset E360 User Manual

Operating the base station on the PABX

Restoring the base station to

factory settings

When the settings are restored all handsets
are de-registered. Each individual setting is
restored. Only the date and time are
retained.
¢ ¢
§Menu§
Settings
¢ ¢
§OK§
Base Reset
Operating the base
station on the PABX
The following settings are only needed
when your PABX requires them. Please refer
to the user guide for your PABX.
Changing the dialling mode
¢
L N O 1 1
§Menu§
its for dialling mode: Q = Dual-tone multi-
frequency dialling (DTMF); 1 = Pulse dial-
¢
§OK§
ling (PD)
Switching temporarily to dual-tone
multifrequency dialling (DTMF)
If your PABX is still using pulse dialling (PD)
but tone dialling is required for a connection
(e.g. to play back the network mailbox), you
have to switch temporarily to tone dialling.
Requirement: You are currently conducting
a call or have already dialled an external
number.
Press the asterisk key P. Tone dialling is
activated for this connection only.
22
¢ ¢
§OK§ §OK§
Base
¢
Enter dig-
Setting the flash time
¢
L N O 1 2
§Menu§
its for flash time: Q = 80 ms; 1 = 100 ms;
2 = 120 ms; I = 180 ms; 4 = 250 ms;
5 = 300 ms; L = 600 ms; M = 800 ms
¢
§OK§
Changing pause after line seizure
You can set the length of the pause inserted
between pressing the talk key c and send-
ing the phone number.
¢
L N O 1 O
§Menu§
digits for the current pause length:
1 = 1 sec.; 2 = 3 sec.; I = 7 sec.
Changing the pause after the recall
key
¢
L N O 1 4
§Menu§
digits for the current pause length: 1
ms; 2 I = 3200 ms
1600 ms
= ;
¢
Enter dig-
¢
Enter the
¢
§OK§
.
¢
Enter the
800
¢ =
§OK§