Harman Stove Company TLC 2000 Stove Operator's Manual page 8

load of dry wood. After adding the fuel, leave air setting at
Remove
maximum for 5 to 15 minutes. Then adjust the air controls
Cleanout Plate
and blower speed for the desired heat output.
To Burn As A
Fireplace Stove
Reloading.
coal bed, you should be able to reload the stove, allow some
burning at the maximum air setting, and reset the air control in
about five minutes.
contain more heating capacity (BTU's) per load than do soft-
woods. Wood should be split and stored under cover for "sea-
soning" - a year is recommended. Your stove is not an incin-
erator - do not burn garbage, painted or treated wood, plastic,
or other debris.
Keep all combustibles, including fuel, beyond the code-required
clearance distance (48" or 1215 mm in the U.S., 1525 mm or
60" in Canada). Never store fuel in front of the stove where
it could interfere with door operation, safe loading, and ash
removal.
vection blower, adjust the control from low to high by turning
the knob located on the blower cord.
Removing Wood Ashes.
on the ash door and open. Pull the ash pan out by the handle.
Lift the handle to the vertical position to carry the ashes to a
disposal location. Close the ash door while you are disposing
of the ashes. The fire will get very hot if the bottom door is
left open even for a short period. Replace the ash pan. Re-
move ashes from the fire chamber periodically by shaking the
grates. Wood burns best with an ash bed under the wood;
therefore, do not shake all of the ashes down.
sive ash buildup can prevent proper venting of exhaust gases.
Also do not overfill the ash pan. Ash buildup between the ash
pan and the grates can cause them to overheat and wear out
prematurely.
Operating as a Fireplace.
the front load door open. In this mode of operation you get a
true fire sound as well as appearance. Due to the crackling
and popping of burning wood it is necessary to place the op-
tional screen over the door opening. This prevents sparks from
entering the room just like a screen over a fireplace.
place. This is done by lifting up on the tab on the front of the
plate.
screen over the door opening. Push on the screen until the
two spring clips snap into place. To remove the screen, pull
on the gold handle.
TLC 2000 Coal Stove
Once you have prepared and maintained a thick char-
Select hardwoods if possible, as they are heavier and
Keep the area around the stove free from clutter.
Blower. To regulate the speed of the optional con-
Always wear gloves to remove the ash pan Lift the latch
Never let the ashes build up to over 3" in depth. Exces-
The TLC 2000 is tested and approved to be burned with
The clean-out plate should be removed to burn as a fire-
To install the screen, open the glass door and place the
8