Energy Conservation Settings; Auto Power-Off At A Designated Time; Auto Power-Off After The End Of Broadcast; Auto Power-Off When There Are No Operations Performed - Sharp AQUOS LC-42D85X Operation Manual

Watching TV

Energy conservation settings

Auto power-off at a designated time

This function is conveniently used when, for instance,
going to bed while watching TV.
Press SLEEP.
1
• Remaining time displays when sleep timer has
been set.
Sleep Timer: Remain 2 hr. 00 min.
Each time you press SLEEP, the remaining
2
time switches as shown below.
0 hr. 30 min. 1 hr. 00 min.
Off 2 hr. 30 min.
NOTE
• The sleep timer indicator on the TV lights up when the time
has been set.
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select "Off" by pressing SLEEP to cancel the sleep timer.

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
• Power control menu displays.
Press a / b to select "No Signal Off", and then
3
press ENTER.
Press c / d to select "Enable", and then press
4
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme finishes, this function may not
operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
Press MENU and the MENU screen displays.
1
30
2
3
4
NOTE
• "Disable" is the factory preset value.

Ecology

When set to "Yes", the TV activates the following
power saving mode.
• "OPC" set to "On" (Page 34)
• "Standby Mode" set to "Mode2" (Page 30)
1 hr. 30 min.
• "No Operation Off" set to "3hr." (Page 30)
• "No Signal Off" set to "Enable" (Page 30)
2 hr. 00 min.
1
2
3
4
NOTE
• Ecology mode cannot be deactivated by selecting "No".
Each setting must be changed individually to deactivate
Ecology mode.

Reducing the start-up time

You can reduce the TV's start-up time after turning on
the power with the remote control unit.
1
2
3
4
Selected item
Mode1*
Mode2
* Standby power consumption in Mode 1 setting is
approximately 28W.
Press c / d to select "Power Control".
• Power control menu displays.
Press a / b to select "No Operation Off", and
then press ENTER.
Press a / b to select "30min." or "3hr.", and
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU and the MENU screen displays.
Press c / d to select "Power Control", and
then press ENTER.
• Power control menu displays.
Press a / b to select "Ecology", and then
press ENTER.
Press c / d to select "Yes", and then press
ENTER.
Press MENU and the MENU screen displays.
Press c/d to select "Setup".
Press a/b to select "Standby Mode", and
then press ENTER.
Press c/d to select "Mode1" or "Mode2", and
then press ENTER.
Description
TV starting time is approximately 1 second
from standby.
Power consumption is less than 1W.