Energy Conservation Settings; Auto Power-Off At A Designated Time; Energy Save; Auto Power-Off After The End Of Broadcast - Sharp AQUOS LC-32D77X Operation Manual

Watching TV

Energy conservation settings

Auto power-off at a designated time

This function is conveniently used when, for instance,
going to bed while watching TV.
Press SLEEP.
1
• Remaining time displays when sleep timer has
been set.
Sleep Timer: Remain 2 hr. 00 min.
Each time you press SLEEP, the remaining
2
time switches as shown below.
0 hr. 30 min.
Off
NOTE
• The sleep timer indicator on the TV lights up when the time
has been set.
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select "Off" by pressing SLEEP to cancel the sleep timer.

Energy save

This function enables you to automatically reduce the
backlight brightness in order to decrease the power
consumption and increase the backlight life span.
Press MENU and the MENU screen displays.
1
Press c / d to select "ECO".
2
• ECO menu displays.
Press a / b to select "Energy save", and then
3
press ENTER.
Press a / b to select "Standard" or
4
"Advanced", and then press ENTER.
Selected item
Standard Reduces the backlight brightness by 25%.
Advanced Reduces the backlight brightness by 50%.
Off The backlight brightness is the same value
of your settings in the selected "AV MODE ".

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day.
30
52D77X.indb 30 52D77X.indb 30
1 hr. 00 min. 1 hr. 30 min.
2 hr. 30 min. 2 hr. 00 min.
Description
Press MENU and the MENU screen displays.
1
Press c / d to select "ECO".
2
• ECO menu displays.
Press a / b to select "No signal off", and then
3
press ENTER.
Press c / d to select "Enable", and then press
4
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme finishes, this function may not
operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
Press MENU and the MENU screen displays.
1
Press c / d to select "ECO".
2
• ECO menu displays.
Press a / b to select "No operation off", and
3
then press ENTER.
Press a / b to select "30min." or "3hr.", and
4
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.

Quick start

You can reduce the TV's start-up time after turning on
the power with the remote control unit.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press a/b to select "Quick start", and then
3
press ENTER.
Press c/d to select "On" or "Off", and then
4
press ENTER.
Selected item
On The TV quickly starts up from standby,
22 W or more of power consumption is
required during standby.
Off Power consumption is less than 1 W.
Description
2/17/09 5:13:21 PM 2/17/09 5:13:21 PM