Harman Stove Company Advance Pellet Stove Installation And Operating Manual page 23

Maintenance - Combustion Intake Cover
Cover Retainer Handle
Fig. 46
These surfaces must be even to
close retainer handle.
Fig. 47
Intake Cover Handle
ESP Probe
(in rear of flue
tube)
Fig.48
Combustion Fan Blade
Combustion
Intake Cover
Right Side Tab
Right Side Retaining Slot
Cleaning and Maintenance for the
Combustion Intake Cover
You will need to remove the combustion
intake cover to clean the fan blades and rear flue
tube.
Figure 46
Rotate the retainer cover handle counter-clockwise
upward as far as it will go (approximately 90
Figure 47
Hold the intake cover handle and pull until the side
of the cover at the retainer handle end comes away
from the stove body, approximately 15-20
the right side tab out of the retaining slot.
Figure 48
Clean and inspect the fully exposed combustion
fan blade and flue tube.
Reinstall the combustion intake cover by
first sliding the right side tab into the retainer slot
seen in Figure 47.
Rotate the cover inward until the cover fits
into its hole.
Make sure the two faces (Fig.46) of the
cover and retainer spacer are even and rotate the
retainer handle clockwise until it stops.
CAUTION
Excessive cleaning force could bend the
small stainless steel ESP Probe, causing
damage.
23
o
).
o , slide