Leg Extension Seat Installation; Installing The Leg Extension Chrome Tubes And Foam Rollers - Bowflex Ultimate Assembly Manual

Assembling Your BOWFLEX Ultimate Leg Assembly
18
Step 3: LEG EXTENSION SEAT INSTALLATION
Locate the following parts:
• Leg extension assembly (from previous step)
• Leg extension seat assembly (Item #61)
• Two (2) 1/4"X2-3/4" bolt (Item #71)
• Two (2) 1/4" nylon lock nuts (Item #72)
• Four (4) 1/4" washers (Item #55)
Place the leg extension seat (Item #61) on top of
the horizontal tube on the leg extension assembly
(Item #62) with the hinge brackets facing the direction
shown in Figure R.
Insert two 1/4"X2-3/4" bolts (Item #71) with 1/4"
washers (Item #55) through the brackets on the
bottom of the leg extension seat (Item #61).
Install 1/4" washers (Item #55) onto the bolts and
securely tighten 1/4" nylon lock nuts (Item #72) on the
bolts.
Components for this step
are in the Leg Extension Box
Step 4: INSTALLING THE LEG EXTENSION
CHROME TUBES AND FOAM ROLLERS
Locate the following parts
• Portion of leg extension attachment already
assembled
• Three (3) leg extension chrome tubes (Item #66)
• Six (6) leg extension rollers (Item #65)
• Six (6) leg extension tube end caps (Item #69)
• Two (2) 73.50" leg extension cables (Item #67)
Back out the screws that are in the end holes of the
leg extension pivot tube (Item #64) just enough to
slide the chrome tube through the holes.
Slide Chrome tubes into all three holes as shown in
Figure S.
Slide the LARGE LOOP of the leg extension cables
(Item #67) onto the lowest chrome tube, one on each
side of the leg extension pivot tube.
Slide the foam rollers (Item #65) onto the
chrome tubes (Item #66) as shown in Figure T.
Push the roller end caps (Item #69) into the
ends of the chrome tubes (Item #66) as shown
in Figure T.
Note: You may need to use a rubber mallet
to get the end caps securely into the
chrome tubes.
61
72
55
Figure R
Components for this
step are in Leg
Extension Box
69
65
Unit appears like
this following this
assembly step
Hinges
55
71
Unit appears like
this following this
assembly step
Figure S
66
Figure T