Golden Technologies Alante GP201SS Owner's Manual page 17

Alante´ GP201 Manual
ARM INSTALLATION
1)
2)
in the down position.
3)
4)
NOTE:
mounting plates will be free to move around the arm adjustment knobs.
JOYSTICK CONTROLLER INSTALLATION
1)
2)
Joystick
Controller
Receiver
ASSEMBLY Cont.
Loosen (but do not remove) the arm width adjustment knobs at
the rear of the seat frame.
Insert the lower arm tube into the arm receiver at the rear of
the seat frame. (Figure 13)
Be sure the arm pad is facing forward when the armrest is
Find a comfortable width and tighten the knob.
Repeat on the opposite side of the unit.
When the arm adjustment knobs are tight, the lap belt
With the seat installed and arms secured in place, slide the
joystick controller extension arm into the joystick controller
receiver. Fig. 13
Find a comfortable position for the joystick controller and secure
controller receiver.
Figure 14
Figure 13
Lower Arm Tube
Joystick
Controller
Extension
Arm
17
Revised 9-14-07
Figure 15