Mounting The Rear Top Skirtboard; Positioning And Levelling The Appliance; Extraction Of The Combustion Products - Smeg Oven Instructions For The User

For operation on 380-415V3N~: use an H05V2V2-F type five-core
2
cable (5 x 4 mm ).
For operation on 380-415V2N~: use an H05V2V2-F type four-core
2
cable (4 x 6 mm ).
For operation on 220-240V~: use a three-core cable 3 x 10mm²
This type of connection is only permitted when using the special kit,
available from assistance centres (part num. KITMT code 902263)
The end to be connected to the appliance must have an earth wire
(yellow-green) at least 20 mm longer than the others.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR
THINGS CAUSED BY NON-OBSERVANCE OF THE ABOVE PRESCRIPTIONS.

6.2 Extraction of the combustion products

The combustion products must be extracted by means of hoods connected to a natural draught chimney
whose efficiency is certain or via forced extraction. An efficient extraction system requires precision
planning by a specialist qualified in this area and must comply with the positions and distances indicated
by the applicable standards. When the job is complete, the installer must issue a certificate of conformity.

6.3 Mounting the rear top skirtboard

• Loosen nuts B.
• Position the skirt above the top, taking care to align
pins C with holes D.
• Secure the skirt to the top by tightening screws A.

6.4 Positioning and levelling the appliance

After making the electrical and gas connections, level the appliance on the floor by means of its four
adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the
model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110
to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the
lowest point (movable part which rests on the floor).
Instructions for the installer
220-240V~
20 mm
2
10 mm
29