Smeg Oven Instructions For The User page 22

Instructions for the installer
13.4.1 Connection to natural and city gas
Make the connection to the gas mains using a rubber hose whose
specifications comply with the current regulations (verify that the reference
standard is stamped on the hose).
Screw the hose connector A to the gas connector B of the appliance, placing
the seal C between them. Push the rubber hose D onto the hose connector A
and secure it with the clamp E that is compliant with the current standard.
13.4.2Connection to liquid gas
Both the pressure regulator and the connection to the cylinder must be standards-compliant. Make sure
that the feed pressure complies with the values indicated in the table at point "14.2 Burner and nozzle
characteristics table".
Screw the small hose connector F onto the large hose connector A; connect
the block this makes to the gas connector B (or use the hose connector G
which must be connected directly to the gas connector B) and place the seal
C between them. Push the end of the rubber hose H onto the hose connector
A+F (or G) and at the outlet connector of the pressure reducer onto the
cylinder. Fix the end of the hose H to the hose connector A+F (or G) with the
standards-compliant clamp I.
The hose connector A-F-G illustrated are not supplied with the appliance. Only use standards-compliant
hose connectors.
13.4.3Connection with a flexible steel hose (for all types of gas)
This type of connection can be made on both built-in and free-standing
appliances. Only use standards-compliant steel hoses whose length is not
greater than 2 metres.
Screw the end of the flexible hose L to the ½" OD threaded gas connector
(ISO 228-1) B placing the seal C between them.
At the end of the installation, check for any leaks with a soapy solution, never
with a flame.
49