Yamaha BR250F Service Manual page 65

2. Install the steering column onto the
frame. Grease the upper and lower bear-
ings. Torque the bolts to specification
and bend the lock tab.
Tightening torque:
2.5 m-kg (18 ft-lb)
Tightening torque:
2.0 m-kg (15 ft-lb)
3. Connect the steering relay rods to the
steering column. Torque the flange nut
to specification and install a new cotter
pin.
Tightening torque:
2.5 m-kg (18 ft-lbl
Front
1. Ski spindle center
A C
=
0"'" 6 mm (0 ""' 0.23 in)
B. Ski width
B.
Adjustment
1. Straighten the handlebars and check to
see that the skis are parallel. If not,
loosen the steering relay-rod lock nut.
By turning the steering relay rod, adjust
the ski toe-out to specification. Torque
the lock nut to specification.
Ski stance:
750 mm (29.53 in)
Ski toe-out: 0 - 6 mm (0 - 0.23 in)
5-2
2.
The height of the handlebars can be
adjusted to suit the rider's preference.
After adjusting the handlebars, alternate-
ly tighten the four securing bolts. Main-
tain the specified gap in the steering
clamps. Torque the bolts to specifica-
tion.
Tightening torque:
1.4 m-kg (10 tt-tb)
1. Clamp
2. H andJebar