Chicago Electric 3733 Assembly And Operating Instructions Manual page 5

6. KEEP ALL SAFETY GUARDS IN PLACE, IN PROPER ADJUSTMENT, AND IN
PROPER ALIGNMENT.
7. REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Power
Switch (part #4) is in the "OFF" position before plugging the Power Cord
(part #11) into a grounded, 3-hole, 120 Volt, electrical outlet.
8. THIS TILE SAW IS DESIGNED FOR USE ONLY WITH A 4" WET DIAMOND
TILE SAW BLADE (part #36) REQUIRING A 5/8" DIAMETER ARBOR.
9. USE THE TILE SAW ONLY FOR CUTTING CERAMIC TILE, QUARRY TILE,
MARBLE, TERRA COTTA, AND SLATE WITH A MAXIMUM THICKNESS OF
1-1/16".
10. DO NOT USE THE TILE SAW FOR CUTTING METALS, OR FOR CUTTING
CURVES. This may cause the Tile Saw Blade (part #36) to break, and reduce its
service life.
11. MAKE SURE THE TILE SAW BLADE (part #36) REMAINS WET AT ALL
TIMES WHILE CUTTING.
12. TO AVOID ELECTRICAL SHOCK AND/OR DAMAGE TO THE TILE SAW, DO
NOT FILL THE BODY'S (part #19) WATER BATH ABOVE THE WATER FILL
LINE. (See Figure D.)
13. AVOID SPLASHING WATER ON THE MOTOR, SWITCHES, OR ANY ELEC-
TRICAL COMPONENT. Make sure to stand on a dry, insulated surface, such as
a rubber mat, while using this Tile Saw.
14. FOR YOUR SAFETY: In extreme working conditions, sensors in the Tile Saw will
automatically switch off the Motor to prevent overheating. The Tile Saw will
automatically reset after it has sufficiently cooled.
15. CAUTION: Never pass hands directly in front of or over the Tile Saw Blade
(part #36) when cutting a workpiece. Always keep hands and fingers a safe
distance away from the spinning Tile Saw Blade.
16. PRIOR TO STARTING THE TILE SAW, MAKE SURE ALL ADJUSTING KEYS
AND WRENCHES ARE REMOVED FROM THE TOOL.
17. ALLOW THE TILE SAW BLADE (part #36) TO SPIN UP TO FULL SPEED
BEFORE FEEDING A WORKPIECE INTO THE BLADE. When turning off the
Tile Saw, allow the Tile Saw Blade to spin down and stop on its own. Do not
press against the Tile Saw Blade to stop it.
SKU 03733 PAGE 5