Table of Contents
Advertisement
Quick Links
RECIPROCATING SAW
Model 36595
Assembly and Operating Instructions
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright
1997 by Harbor Freight Tools
. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Advertisement
Table of Contents
Related Manuals for Chicago Electric 36595
Summary of Contents for Chicago Electric 36595
- Page 1 RECIPROCATING SAW Model 36595 Assembly and Operating Instructions ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at http://www.harborfreight.com ® Copyright 1997 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
-
Page 2: Specifications
Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Page 2 -- SKU: 36595 Rev 03/00... - Page 3 To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code 25249.5, et seq. ) Page 3 -- SKU: 36595 REV 01/04...
-
Page 4: Voltage Warning
Always inspect extension cords for any damage. If there are any loose, frayed or exposed wires, damaged insulation, or defective connections, replace the cord. Harbor Freight Tools can supply UL listed and outdoor rated cords in multiple AWG ratings if needed. Page 4 -- SKU: 36595... - Page 5 Step 2: With the supplied Hex Key Wrench, loosen but do not remove SCREW (#4) as shown in Figure 1. Screw (#4) Figure 1 — Blade Assembly Step 3: Slide selected Blade, teeth down, into the BLADE HOLDER as far as possible. Step 4: Tighten the SCREW (#4) firmly. Page 5 -- SKU: 36595...
- Page 6 Step 4: You can change the angle of your cutting by changing the angle of the ADJUSTABLE BOTTOM PLATE as shown in Figure 3. Wall Flat Cutting Wall Angle Cutting Figure 3 — Adjustable Bottom Plate Angle Adjustment Your Reciprocating Saw is ready for use. Page 6 -- SKU: 36595...
-
Page 7: Operation Cautions
TRIGGER SWITCH, then press the Locking Button as shown in Figure 4. CAUTION Locking Button When Cutting Metal, Use Cutting Oil to Cool the Blade or Damage May Result. Trigger Switch (#37) Page 7 -- SKU: 36595... - Page 8 Step 8: To stop the Saw, release the TRIGGER SWITCH. If the TRIGGER SWITCH has been locked in the “ON” position, press and release the TRIGGER SWITCH. This will stop the Saw. Step 9: Return the Adjustable Speed Switch to the “1” setting. Page 8 -- SKU: 36595...
-
Page 9: Maintenance
Step 5: Over time, the CARBON BRUSHES (#32) in the Motor will wear. If the CARBON BRUSHES wear too much, the Saw will not work. Take the Saw to Harbor Freight Tools or a qualified technician for service. Page 9 -- SKU: 36595... - Page 10 Page 10 -- SKU: 36595 REV 11/02...
- Page 11 Page 11 -- SKU: 36595 REV 11/02...