Product Description - Chicago Electric 3733 Assembly And Operating Instructions Manual

4” tile saw with pvc tray

Hide thumbs

Table Of Contents

Table of Contents

The Tile Saw features a built-in water supply that keeps its Tile Saw Blade cool,

reduces dust and debris, and is easy to clean. Its efficient design returns water

directly to the reservoir and is accurate enough for most ceramic tile, quarry tile,

marble, terra cotta, and slate jobs. (See Figure B.)

CERAMIC TILE

(NOT INCLUDED)

BODY

(#19)

FIGURE B

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: For additional references to the parts listed below, refer to the Assembly

Diagram on page 12.

Warning: Always wear ANSI approved, full face, safety shield and ear protection when

using this product.

To Change A 4" Diamond Tile Saw Blade:

CAUTION: Make sure the Power Switch (part #4) is in its "OFF" position, and

the Tile Saw is disconnected from its electrical outlet before performing this

procedure. (See Figure B.)

Remove the Screw (part #16). Then, remove the Table (part #1) from the Tile

Saw unit. (See Figure B above, and Figure C next page.)

Remove the Nut (part #38). Then, remove the Outer Flange (part #37).

(See Figure C.)

SKU 03733