Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. Do not use a tool for a purpose for which it was not intended. Disconnect power. Unplug charger when not in use. SKU 37412 Page 2...
Page 3
20. Never operate without all guards in place. Do not disable blade guard when cutting. 21. Guard against kickback. Kickback occurs when the saw stalls and is drivenbackwards toward the operator. When this happens, release switch immediately. SKU 37412 Page 3...
The Battery does not come charged from the factory. Charge before using. Part numbers below refer to Parts List on page 8. Charging room temperature: 50 F - 104 Insert the Battery (#14) into the black Charger Base. The Battery will only insert one way. SKU 37412 Page 4 Rev 09/98, 10/03...
Replace washer (#2) and nut bolt (#1). Tighten with hex key (#48) while pressing on the stop button (#17). Verify stop button is in the up (unlocked) position. Replace key to its storage hole in the housing of the saw. Rev 09/98, 05/02 SKU 37412 Page 5...
Page 6
Never attempt to dis- charge a tool’s battery by continuing to pull the tool trigger. When tool performance begins to diminish, stop the tool, re-charge the battery and use the fresh battery for optimal performance. SKU 37412 Page 6...
If the tool is not operating normally, making unusual noises, or appears defective, stop using it immediately and get it repaired. Clean tool with a damp cloth and light detergent. Do not use solvents as they can damage and crack the plastic parts. SKU 37412 Page 7...