Panasonic SC-HTR310 Operating Instructions Manual page 12

Installing and assembling the rack
Glass top panel assembly
1
Adjust the glass top panel (included)
to protrusion.
• The glass top panel has the front side and back
side. Face up the front side with the sticker.
• The nonslip sheet has been put on the top panel of
the rack. Do not remove the sheet when installing
the glass top panel.
2
Put it down slowly adjusting to the
top panel of the rack.
Note
Lift up and down slowly not to make an impact on the glass.
Shelf assembly
1
Insert the moulded dowel (included) into
the dowel hole on one side.
2
Insert the shelf (included) with a slope
and set it adjusting the shelf groove to the
moulded dowel.
3
Hold the shelf, insert the moulded dowel
into the dowel hole on the other side. Set
the shelf horizontally.
• The height of the shelf can be adjusted at 3 different
levels.
• Change the position of the dowels to move the shelf up or
down.
• Insert the moulded dowel not to lose even when the shelf
is not set.
SC-HTR310
Dowel position
H
Compartment
12
RQTX0151
Upper Middle
Upper shelf 101 131
Lower shelf 101 71
W 448 (both L and R)
D 354
Nonslip
sheet
(Side view)
Glass top panel
SC-HTR210
UNIT: mm
Lower Dowel position
161
41
Compartment
Glass top panel
Protrusion
Sticker
Top panel of the rack
Top panel of the rack
Moulded dowel
Groove (Under the shelf)
Upper
Upper shelf 98
H
Lower shelf 101
W
D
Hole
Shelf
UNIT: mm
Middle Lower
128 158
71 41
700
354