Standard Horizon MATRIX GX2100 Owner's Manual page 58

3. Press the [ SELECT ] soft key. The transceiver will
beep, and the "Last Individual Call" will appear.
4. Press the [ NEW ID ] soft key, then select "
with the CHANNEL knob.
5. Press the [ SELECT ] soft key.
6. Rotate the CHANNEL knob to select the first num-
ber of the MMSI which you want to contact, then
press the [ SELECT ] soft key to step to the next num-
ber.
7. Repeat step 6 to set the MMSI number (nine digits).
8. If a mistake was made entering in the MMSI num-
ber, repeat pressing the [ BACK ] key until the wrong
number is selected, then rotate the CHANNEL knob
to correct the entry.
9. When finished entering the MMSI number, press and
hold the [ SELECT ] soft key.
10. Press the [ SELECT ] soft key, then rotate the CHAN-
NEL knob to select the operating channel you want
to communicate on, then press the [ SELECT ] soft
key. If the channel is not shown in the list, press the
[ MANUAL ] soft key, then rotate the CHANNEL knob
to select the operating channel you want to com-
municate on, then press the [ SELECT ] soft key.
11. Press the [ YES ] soft key to transmit the individual
DSC signal.
12. When an individual call acknowledgment is received,
the established channel is automatically changed
to the channel which is selected on step 5 above
and a ringing tone sounds.
13. Press the [ QUIT ] soft key to listen to the channel to
make sure it is not busy, then press the microphone's
PTT switch and talk into the microphone to the other
vessel.
Page 58
"
GX2000/GX2100