Using Several Handsets; Registering Handsets - Siemens Gigaset C355 Manual

Using several handsets

Registering handsets

You can register up to six handsets on your
base unit.
Automatic registration Gigaset C35 to
Gigaset C355
Important: The handset must not already
be registered to any base unit.
Registering the handset to the Gigaset
C355 base is automatic.
¤
Place the handset in the charging cra-
dle of the base unit with its display fac-
ing forward.
Automatic registration takes around one
minute. While this is happening,
ing appears in the display and the name of
the base, 1, flashes. The handset is
Base
given the lowest available internal
number (1–6). When the handset has reg-
istered, this number appears in the dis-
play, e.g. INT 1. This means that the hand-
set has been allocated the first internal
number. If all internal numbers 1–6 have
been assigned (six handsets are registered
on a base), the number 6 is overwritten if
that handset is in idle status.
Note:
– Automatic registration is not possible when
the base on which you wish to register the
handset is being used to make a call.
– A key press cancels automatic registration.
– The name of the handset can be changed
(page 34).
Manually registering the Gigaset C35
to Gigaset C355
You must activate manual registration of
the handset at both the handset and the
base station.
After it has registered, the handset returns
to idle status. The internal number of the
handset appears in the display, e.g.
The registration process is cancelled after
60 seconds. If the handset has not regis-
tered within this time, repeat the process.
On the handset
Menu§
Handset
~
Register-
On the base
ù
Registering other handsets
Other Gigaset handsets and handsets of
other GAP-compatible products are regis-
tered as follows.
On the handset
¤
Start to register the handset as
described in its operating instructions.
On the base
ù
Using several handsets
¢ ¢
Settings Handset
Enter the system PIN of the
base (the default is 0000) and
press . You will see, e.g.
§OK§
Registering Base 1
the display.
Press the registration/paging
key on the base (page 2) and
hold for about 3 seconds..
Press the registration/paging
key on the base (page 2) and
hold for about 3 seconds.
INT 1.
¢
Register
flashing in
31