Table of Contents
Advertisement
Opening/closing the battery cover
¤
To close, position the cover 2 so that it
is open slightly and push it upwards
towards the loudspeaker 1 until it clicks
into place.
¤
To open, press down on the cover 2
below its upper end and slide it down
away from the loudspeaker 1.
Placing the handset in the base and
registering it
¤
Place the handset in the charging cra-
dle of the base unit with its display fac-
ing forward.
The handset registers automatically.
Registration takes about 1 minute.
While this is happening,
appears in the display and the name of the
base,
Base
1, flashes. The handset is given
the lowest available internal number
(1–6). When the handset has registered,
this number appears in the display,
e.g.
1. This means that the handset
INT
has been allocated the first internal
number. If all internal numbers 1–6 have
been assigned (six handsets are registered
on a base), the number 6 is overwritten if
that handset is in idle status.
Note:
– Automatic registration is not possible when
the base on which you wish to register the
handset is being used to make a call.
– A key press cancels automatic registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 31).
– The name of the handset can be changed
(page 34).
1
2
Registering
Preparing to use the phone
¤
Leave the handset in the charging cra-
dle in the base to charge up the batter-
ies.
Note:
– The handset may only be placed in the base
provided for it.
– When the handset is in the base, it charges
even if it is switched off. You will see the
charge status in the display.
– If the handset has switched itself off
because the batteries are flat and if it is
then placed in the base, it will switch itself
on automatically.
If you have any questions or problems see
page 41.
First battery charge and discharge
Battery charging is indicated in the top
right of the display by a flashing battery
icon e, V or U. During handset oper-
ation, the battery icon indicates the
charge status of the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged and discharged through use.
¤
To do this, leave the handset in the
base without interruption until the
battery icon stops flashing in the dis-
play (approx. 6h). Your handset need
not be switched on for it to charge.
¤
Once the batteries are fully charged,
remove the handset from the base and
do not put it back again until the batter-
ies are fully discharged.
Note:
After the first battery charge and discharge
you may replace your handset in its base after
every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and insert
them in again.
u
The batteries may warm up while they
are charging. This is not dangerous.
7
Hide quick links:
Advertisement
Table of Contents
