Disc Operations - Panasonic SC-HC3 Operating Instructions Manual

Disc operations

Basic play
 Press [^] to turn the unit on.
 Press [CD ;, OPEN/CLOSE] to open the sliding
door and then set the CD in place.
Center part
 Press [CD ;, OPEN/CLOSE] again to close the
sliding door.
Keep fingers away from the sliding door when it is
closing to avoid possible minor injuries.
 Press [CD q/h] or [OK] to start play.
 Press [VOL +, –] to adjust the volume.
Note
• Be sure to press the [CD ;, OPEN/CLOSE] button to
open and close the sliding door. Damage may occur if
the sliding door is forced closed.
• Be careful of CD hitting the sliding door while being
removed.
To Action
stop
Press [g].
pause
Press [CD q/h].
Press again to resume play.
skip/search
Press [u/t] or [y/i] to skip.
Press and hold [u/t] or [y/i] to
search.
Note
• You can search during play or while
paused.
• You cannot search through MP3 files.
• You can only search within the current
track during program play, one track
repeat, and random play.
skip album
Press [e, r, ALBUM] in the play mode.
Press [e, r, ALBUM] once and then the
MP3
numeric buttons in the stop mode.
direct CD Press the numeric buttons to select
access play the desired track.
MP3
(Play starts
 Press [e, r, ALBUM] to select the
with the
album.
track you
 Press [y/i] once and then press
select.)
the numeric buttons to select the
8
desired track.
• Tilt the CD to the left and slide
it in place.
• Label must face outward.
Press until you hear it clicks
into place.
Program play
The function allows you to program up to 24 tracks.
CD
 Press [CD q/h] and then [g].
 Press [PROGRAM].
 Press the numeric buttons to select tracks.
Repeat this step to program other tracks.
 Press [CD q/h] or [OK] to start play.
MP3
 Press [CD q/h] and then [g].
 Press [PROGRAM].
 Press [e, r, ALBUM] to select your desired album.
 Press [y/i] once and then press the numeric
buttons to select tracks.
 Press [OK].
Repeat step 3 to 5 to program other tracks.
 Press [CD q/h] to start play.
To Action
cancel program Press [PROGRAM] in the stop mode
mode to clear "PGM" indicator from the
display.
replay the
Press [PROGRAM] then [CD q/h].
program
check program
Press [u/t] or [y/i] when
contents
"PGM" is displayed in the stop mode.
To check while programming, press
[PROGRAM] twice after "PGM"
appears, then press [u/t] or
[y/i].
Press [DEL] in the stop mode.
clear the last
track
clear all
Press [g] in the stop mode.
programmed
"CLR ALL" is displayed.
track
Within 5 seconds, press the button
again to clear all tracks.
Note
• When you try to program more than 24 tracks "PGM
FULL" appears.
• The program memory is cleared when you open the
sliding door.
CD
• During program play, you can search backward or
forward only within the current track.