Quick Start; Quick Power On - Panasonic SDR-H86 Operating Instructions Manual

Quick start

This unit will resume recording pause mode
about 0.8 seconds after the LCD monitor is
reopened.
≥ Start time will not shorten if there is no SD
card inserted.
/
SDR-T55 SDR-T50
Start time will be shorten if the [Built-
inMemory] is selected in the [MEDIA
SELECT], even if there is no SD card
inserted.
SDR-H86
Start time will be shorten if the [HDD] is
selected in the [MEDIA SELECT], even if
there is no SD card inserted.
¬ Change the mode to
1
Select the menu. (l 25)
[SETUP] # [QUICK START] # [ON]
2
Close the LCD monitor while
the mode is set to
The status indicator A flashes green and the
unit goes into quick start standby mode.
3
Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in quick start standby mode
about 70% of the power used in
recording pause mode is being
consumed, so the recording time will
be reduced.
≥ Quick start standby mode is cancelled if
j about 5 minutes elapsed
j mode is set to
≥ It may take some time for automatic white
balance to adjust.
≥ In the quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 27) is set to
[5 MINUTES] and the unit automatically
goes into quick start standby mode, close
the LCD monitor and then open it again.
.
≥ Turn the unit off using the power button.

Quick power on

When the unit is turned on with the mode set
to
pause mode after about 1.9 seconds.
.
Select the menu. (l 25)
[SETUP] # [QUICK POWER ON] #
[ON]
≥ In the quick power on mode, the zoom
magnification becomes 1k.
, the unit will enter the recording
37
VQT2N67