Sanyo PLC-XE50A Owner's Manual page 49

Multimedia projector
Hide thumbs Also See for PLC-XE50A:
Table of Contents

Advertisement

Select one of the operations.
Ready......... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on
the remote control is pressed. When the
condition of Ready elapses 60 minutes, the
projector will be turned off automatically.
Shut down... When the lamp has been fully cooled
down, the power is turned off.
Off............ Power management function is off.
Then set the countdown timer with the Point
✔Note:
• Factory default is "Ready: 5 min. "
On start
When this function is set to "On, " the projector is
automatically turned on just by connecting the AC power
cord to an outlet.
✔Note:
•Be sure to turn the projector off properly (see "Turning Off
the Projector" on page 20). If the projector is turned off
in the incorrect sequence, the On start function does not
operate properly.
Lamp control
You can change the brightness of the screen.
High ........... Brighter than the Normal mode.
Normal ....... Normal brightness
Auto ........... The brightness according to the input
signal.
Remote control
This projector provides two different remote control codes;
the factory-set, initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when several projectors or video equipment
are operated at the same time.
When the projector is operated in "Code 2, " both the
projector and the remote control must be switched to
"Code 2. "
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for more than 5 seconds. After changing the code,
make sure the remote control operates properly.
buttons.
7 8
On start
Remote control
✔Note:
•When different codes are set on the
projector and on the remote control, any
operation cannot be made. In that case,
switch the code on the remote control to
fit the code on the projector.
•if the batteries are removed from the
remote control for a long period of time,
the remote control code will be reset.
Setting
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point
buttons, and
7 8
go to the timer with the
Point
buttons and set
ed
time with the Point
7 8
buttons.
/
Press and hold
MENU and
IMAGE buttons
for more than 5
seconds.
49
49

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents