Sanyo PLC-XE50A Owner's Manual page 46

Setting
Capture
This function enables you to capture the image being
projected and use it for a start-up display or interval of
presentations.
After capturing the projected image, go to the Logo
select function and set it to "User. " Then the captured
image is displayed when the projector is turned on next
time or the NO SHOW button is pressed (p 25).
To capture the image, select "Yes. " To cancel the Capture
function, select "No. "
✔Note:
•Before capturing an image, select "Standard" in the
Image Select Menu to capture a proper image (pp.31-
32, 39-40).
•A signal from a computer can be captured up to
XGA(1024x 768). A signal from video equipment can
be captured except for 720p, 1035i, and 1080i.
•When you capture the image that has been adjusted
by the Keystone function, the adjusted data is
automatically reset and the projector captures an
image without keystone adjustment.
•When the Logo PIN code lock function is "On, "
Capture menu cannot be selected.
•When you start to capture a new image, the
previously stored image is cleared even if you cancel
the capturing.
•User cannot be selected when the image is not
captured.
Logo PIN code lock
This function prevents an unauthorized person from
changing the screen logo.
Off...... the screen logo can be changed freely from
the Logo select menu (p.45).
On...... the screen logo cannot be changed without
the Logo PIN code.
If you want to change the Logo PIN code lock setting,
enter a Logo PIN code along the following steps. The
initial Logo PIN code is set "4321" at the factory.
46
Capture
Select "Yes" to capture
the projected image.
Select "Yes" to
stop capturing.
Logo PIN code lock