Listening To Tapes - Panasonic SC-AK44 Operating Instructions Manual

3
2
SC-AK44
only
4
1
2
3
SC-AK44
only
4
SC-AK44
SC-AK33 SC-AK22 SC-AK12
5
A
SC-AK44
SC-AK33
1
You can use either deck 1 or deck 2 for tape playback.
5
The unit can play normal, high and metal position tapes.
It identifies the type automatically.
2
Use normal position tapes.
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
4
Front side
Tape direction
To stop tape playback
Press [L].
A
•
•
•
•
Deck in use
SC-AK22 SC-AK12
•
FLAT

Listening to tapes

SC-AK44 -AK44
SC-AK33 SC-AK22 SC-AK12
Press [TAPE, DECK 1/2].
The unit will come on automatically.
If the unit was off and a cassette was loaded, play will start
automatically (One touch play function).
Press [c DECK 1 OPEN] or [c DECK 2 OPEN] and
insert the tape.
Insert the tape with the exposed tape facing down.
Close the holder by hand.
SC-AK44
only
Press [REV MODE] to select the reverse mode.
Every time you press the button:
: One side is played.
: Both sides are played.
: Both sides are played 8 times each.
To listen to 2 tapes consecutively
Load a tape into each deck and select "
be played 8 times each.
SC-AK44
Press [// J] or [-] to start playback.
[ ]
- : The forward side (front side) will play.
[// J]
: The reverse side will play.
SC-AK12
SC-AK33 SC-AK22
Press [-] to start playback.
One side is played, then playback stops automatically.
To play on the other side of the tape, turn the tape over and
-
press [ ].
Adjust the volume.
To change the deck to be used
Press [TAPE, DECK 1/2] to select the deck you want to use when
you load cassettes into both decks.
Notes
Playback is momentarily interrupted while playing back tapes, if you
open the other deck.
Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
SC-AK44
Endless tapes can get caught up in the deck's moving parts if used
incorrectly. Use tapes appropriate to this unit's auto-reverse mecha-
nism.
SC-AK33 SC-AK22 SC-AK12
Failure to operate these tapes correctly may cause the tape to wind
around the revolving parts. Always read the instructions provided
with your tapes.
". Both tapes will
19
RQT5621