Misfeed In The Saddle Stitch Finisher - Sharp AR-C170M Operation Manual

SADDLE STITCH FINISHER

Misfeed in the saddle stitch finisher

When a misfeed occurs in the saddle stitch finisher, remove the misfed paper following the procedure below.
1 Unlatch the saddle stitch finisher and slide
it away from the main unit.
NOTE
The saddle stitch finisher and the machine are
connected at the rear. Exercise caution when pulling
them apart.
2 Remove the misfed paper from the main
unit.
3 If there was no misfed paper in step 2, pull
roller rotating knob B on the punch unit
towards you and rotate it. (Only when an
optional punch unit is installed.)
Roller rotating
knob B
Open the top cover.
4
3-10
After removing the
misfed paper, open and
close the duplex bypass/
inverter to reset the jam
indicator. ("Misfeed in
the Fusing area" step 1
or 4 on page 2-20)
Rotating roller rotating
knob B releases the
caught paper.
Remove the misfed paper.
5
6 Close the top cover.
7 Remove the misfed paper from the stapler
compiler.
Open the saddle stitch section cover.
8
9 Remove the misfed paper.
Remove the paper
gently, taking care not to
tear it.
Be careful not to tear the
misfed paper during
removal.
Be careful not to tear the
misfed paper during
removal.