Misfeed Removal; G Misfeed Removal Guidance; Misfeed Removal Guidance - Sharp AR-C170M Operation Manual

MISFEED REMOVAL

When a misfeed has occurred during printing, the message "MISFEED HAS OCCURRED." will appear in the touch
panel display of the operation panel and printing output will stop. The approximate locations of possible misfeeds are
indicated by " " in the illustration below. The page numbers for detailed information for misfeed removal for each
are also shown.
NOTE
Received faxes are all temporarily stored in memory. If a paper misfeed occurs, received faxes cannot be printed.
When the misfeed is removed, the received faxes will print out automatically.
NOTES
G Be careful not to tear
the misfed paper
during removal.
G If paper is accidentally
torn during removal,
be sure to remove all
pieces.
G Take
care not to
damage or leave
fingerprints on the
transfer belt when
removing the misfed
paper.

Misfeed removal guidance

Misfeed removal guidance can be displayed by touching the [INFORMATION] key on the touch panel after a misfeed
has occurred.
INFORMATION
2-18
CAUTION
The fusing unit is hot. Take care in removing paper.
Upper fusing unit
Misfeed in the fusing area,
and exit area (page 2-20)
Misfeed in the duplex
bypass/inverter unit
(page 2-22)
Misfeed in the 20-bin
sorter (page 3-19)
Misfeed in the saddle
stitch finisher (page 3-10)
Misfeed in the reversing
single pass feeder
(see page 7-2 in the "Copy
Functions" section)
Misfeed in the transport
area (page 2-20)
Fusing unit paper guide
Misfeed in the bypass tray
(page 2-19)
Misfeed in the 500 sheet
paper drawer
(page 2-19)
Misfeed in the duplex
module/2 x 500 sheet
paper drawer (page 2-22)
Misfeed in the stand/1 x 500
sheet paper drawer or the
stand/3 x 500 sheet paper
drawer
(page 2-21)
Misfeed in the large
capacity tray
(page 3-22)
Transfer belt