G Using The Spf Or The Rspf - Sharp AR-206 Operation Manual

SINGLE PASS FEEDER ( AR-SP2 )/REVERSING SINGLE PASS FEEDER (AR-RP1)
Using the SPF or RSPF
G
Be sure to remove any staples or paper clips from the
originals.
G
Damaged or crumpled originals may misfeed in the SPF
or RSPF. It is recommended that these originals be copied
from the original table.
G
Before placing curled or wavy originals into the document
feeder tray, be sure to flatten them. If not, original misfeeds
may result.
G
For best feeding of originals which have binding holes
punched into them, insert them so that the holes are
positioned to the right or along the side guides. In this case
the settings for margin shift and image rotation may need
to be changed to ensure the images are produced in the
desired orientation. See pages 59 and 71.
58
G
Special originals such as transparency film and tracing
paper should not be fed through the SPF or RSPF but
should be copied from the original table.
G
The bypass tray and any tray with non-standard size paper
cannot be used in the duplex copy mode.
G
If the offset stack mode is enabled using user program No.
19, each set of copies will be offset from the previous set
in the sort and group modes.
Stream feeding mode
If the stream feeding mode has been enabled using user program
No. 4, the SPF indicator will continue to blink for approximately
5 seconds after feeding of all originals is completed. While this
indicator is blinking, any new originals placed in the SPF or RSPF
will be fed and copied automatically. See page 36, USER
PROGRAMS.
One-sided copies from One-sided originals
Ensure that no original is left on the original table.
1
Adjust the original guides to the size of the originals.
2
Set the originals face up in the document feeder tray.
3
G
The SPF indicator will light up. If this indicator does not light up, the
originals are not properly set, or the SPF or RSPF is not properly
closed.
G
The ORIGINAL SIZE indicator for the detected original size will light
up, and the paper tray with the corresponding paper size will be
automatically selected.
G
The auto paper select function can be disabled using user program No.
8. If this function has been disabled, use the TRAY SELECT key to
select the desired paper tray. See page 36, USER PROGRAMS.
G
To copy onto a different size paper, use the TRAY SELECT key to
make the selection.
G
The bypass tray cannot be automatically selected.
Ensure that the one-sided to one-sided copying mode is
4
selected in the ORIGINAL TO COPY section of the
operation panel.
G
When no indicator in the ORIGINAL TO COPY section is lit, the
one-sided to one-sided copying mode is selected.