Using The Rspf - Sharp AL-2061 Operation Manual

MAKING COPIES

Using the RSPF

1
Make sure that an original has not been left on the document
glass.
2
Adjust the original guides to the size
of the originals.
3
Set the original(s) face up in the
document feeder tray.
The RSPF indicator on the operation panel
will light up. If this indicator does not light up,
the originals are not properly set or the RSPF
is not properly closed.
4
Select the number of copies and other copy settings, and then
press the [START] key (
24
• Originals that are A5 to A4 and 56 g/m
maximum of 50 pages can be placed at once.
• Straighten curled originals before placing them in the document
feeder tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to
remove any staples or paper clips from them.
• When a copy is made, the edges will not be copied (
For the image loss, see the "SPECIFICATIONS" (p.171).
• When using the margin shift function, check the position of the
margins carefully. (p.37)
• The default output mode for copying from the RSPF is sort mode
(P.32), and a checkmark "
(P.9). If "SORT AUTO SELECT" is disabled in the user programs, the
default output mode will be non-sort mode. (P.138)
• To stop copying in the middle of a run, press the [CLEAR] key (
• For the copy settings, see pages 26 through 39.
2
to 90 g/m
).
" will automatically appear in the display
2
can be used. A
image loss
).
Original face up
).