American Standard Ceramix 2000.10X Installation Instructions Manual page 2

2
POP-UP DRAIN
Remove CLEAR PLASTIC COVER (1).
Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY.
3
REMOVE FLANGE
Thread FLANGE (1) counter-clockwise and remove
FLANGE (1) and FOAM GASKET (2) from drain
Fig. A.
body.
Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
Fig. B.
LOCKNUT (3).
4
INSTALL DRAIN FROM
BELOW FIXTURE
From under side of SINK
install DRAIN BODY (1) up
through drain outlet.
Note: No plumber's putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the SINK.
Install FOAM GASKET (3) and
FLANGE (4) onto drain body
from above SINK and tighten
FLANGE (4) firmly.
6
FLANGE GASKET AND POP-UP KNOB
Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
POP-UP KNOB (1) must be fully down. Fig. B.
Fig. B.
4
3
Fig. A.
1
3
2
Fig. A.
1
2
5
REAR
OF SINK
DRAIN
OUTLET
1
2
Fig. A.
WHITE FOAM
GASKET
DRAIN
NOT VISIBLE
FLANGE
2
Fig. B.
Fig. B.
4
3
TIGHTEN LOCKNUT
Tighten LOCKNUT (1) firmly with Adjustable
Wrench or Channel Locks.
Fig. B. DOWN
DRAIN
BODY
4
1
1
M 9 6 8 7 6 0 R e v . 1 . 3