Other Information - Samsung HW-D7000 User Manual

Other Information

Refer to the chart below when this product does not function properly. If the problem you are
experiencing is not listed below or if the instructions below do not help, turn off the product,
disconnect the power cord, and contact Samsung Electronics at 1-800-SAMSUNG.
Symptom
I cannot eject the disc.
The iPod fails to connect.
Playback does not start.
Playback does not start
immediately when the
Play/Pause button is pressed.
Sound is not produced.
Sound can be heard only from a
few speakers and not all 8.
The sound from the left/right
channels is reversed.
Dolby Digital 7.1 CH Surround
Sound is not produced.
The remote control does not work.
80
English
HW-D7000_XAC_0516.indd 80 HW-D7000_XAC_0516.indd 80
Troubleshooting
Check/Remedy
• Is the power cord plugged securely into the outlet?
• Turn off the power and then turn it back on.
• Check the condition of the iPod connector and Dock.
• Keep the iPod software version up to date.
• Check the region number of the BD/DVD.
BD/DVD discs purchased from abroad may not be playable.
• CD-ROMs and DVD-ROMs cannot be played on this product.
• Make sure that the rating level is correct.
• Are you using a deformed disc or a disc with scratches on the surface?
• Wipe the disc clean.
• The Receiver does not play sound during fast playback, slow playback,and step motion
playback.
• Are the speakers connected properly? Is the speaker setup correctly customized?
• Is the disc severely damaged?
• On certain BD/DVD discs, sound is output from the front speakers only.
• Check if the speakers are connected properly.
• Adjust the volume.
• When listening to a CD, radio or TV, sound is output to the front speakers only.
Select "3D SOUND, NEO:6, PRO LOGIC II" to use all peakers.
• Are the left/right speaker or left/right input/output cables connected properly?
• Check the left/right channel and connect it/them correctly.
• Is there "Dolby Digital 7.1 CH" mark on the disc? Dolby Digital 7.1 CH Surround Sound is
produced only if the disc is recorded with 7.1 channel sound.
• Is the audio language correctly set to Dolby Digital 7.1-CH in the information
display?
• Are you operating the remote within its operational range and within the proper angle
relative to the sensor?
• Are the batteries drained?
• Have you selected the mode (BD-RX, TV, SHIFT) functions of the remote control (BD-RX,
TV, SHIFT) correctly?
2011-05-16 2011-05-16 3:47:17 3:47:17