View The 3D Images - Panasonic Viera TX-L32ET5B Operating Instructions Manual

To view the 3D images
You can enjoy the 3D images in a variety of ways.
(Frame Sequential, Side by Side and Top and Bottom are the supported 3D format.)
■
Playing back 3D-compatible Blu-ray disc (Frame Sequential format)
●
Connect the 3D-compatible player via a fully wired HDMI compliant cable.
● If input mode is not switched automatically, select the input mode connected to the player. (p. 30)
● If you use the non 3D-compatible player, the images will be displayed on 2D mode.
■
3D-supported broadcast
●
Please consult the suppliers of contents or programmes for availability of this service.
■
3D photos and 3D videos taken by 3D-compatible Panasonic products
●
Available in Media Player (p. 63, 64, 66) and Network services (p. 74)
■
2D images converted to 3D
●
Set to [2D 3D] mode in [3D Mode Selection]. (see below)
Put on the 3D Eyewear
1

View the 3D images

2
●
Safety precautions will be displayed when you first watch the 3D image. Select [Yes] or [No] to continue to view
3D images.
If you select [Yes], this message will be displayed again in the same condition after Mains power On / Off
switch is next turned on. Select [No] if you do not want to display this message again.
Note
●
The 3D image or 3D effect may not be available in the following conditions:
VIERA Connect home screen (p. 19) is displayed.
•
[Ext Rec.] of Timer Programming (p. 52) is in progress.
•
Direct TV Recording (p. 80, 82) is in progress.
•
As for the contents of the Frame Sequential format and Side by Side (Full), no images will be displayed in these conditions.
●
3D content will not be correctly visible if the 3D Eyewear is worn upside down or back-to-front.
●
Do not wear the 3D Eyewear when watching anything other than 3D images. Liquid crystal displays (such as
computer screens, digital clocks or calculators, etc.) may be difficult to see while wearing the 3D Eyewear.
●
Do not use the 3D Eyewear as sunglasses.
●
3D effects may be perceived differently depending on the person.
Changing 2D - 3D mode
You can easily change the viewing mode between 2D and 3D using the 3D button.
● This function is not available in PC mode.
Select the mode
3D Mode Selection
2D 3D
3D
2D
[3D] / [2D] / [2D 3D]: Displays the appropriate image that you desire without selecting 3D format.
●
This mode may not work properly depending on the source image format. In this case, select the appropriate 3D
format manually.
■
To change 3D format manually
When the image is not changed properly using [3D], [2D] or [2D 3D] mode, use this manual setting.
During the above operation
(red)
[Original]: Displays the source image as it is.
●
Use to identify the format type of the source image.
"Table of images that can be seen for each [3D Mode Selection (Manual)] and the source image format" (p. 34)
select
set
Select the mode
3D Mode Selection (Manual)
Original
Frame Sequential - 3D
Frame Sequential - 2D
Side by Side - 3D
Side by Side - 2D
Top and Bottom - 3D
Top and Bottom - 2D
2D 3D
●
Items of [3D Mode Selection] vary
depending on the condition.
select
set
33