Using The Wireless Speaker System - Pioneer XV-HTD640 Operating Instruction

Getting started
Using the wireless speaker
system
The wireless speaker supplied with your
system can be used for multichannel sound
with your main setup, or as a second stereo
speaker system.
WIRELESS
SYSTEM SETUP
ENTER
WIRELESS
POWER
MODE
OFF ON
W.SURROUND
Illustration above shows the XW-HTD640
wireless speaker.
1 Switch the wireless speaker off and the
main unit into standby.
SYSTEM SETUP
2 Press
3 If it's not already selected, use
(cursor left/right) to select 'Wireless?' then
ENTER.
press
The current setting is shown in the display.
4 Use (cursor up/down) to select
'W.Surr.' or 'W.Stereo'.
• W.Surr. – Sounds going to the surround
left and right channels are heard through
the wireless speaker (see below for
placement options).
SHIFT
STEREO MODE
VOLUME
W.STEREO MAX
MIN
.
• W.Stereo – Any source playing through
the main system is heard in stereo through
the wireless speakers (multichannel
sources will be downmixed to stereo).
Center
Front left Front right
Subwoofer
Listening position (main room)
ENTER
5 Press .
6 Set the WIRELESS MODE switch on the
wireless speaker to the same mode you
selected above.
• If the mode of the wireless speaker system
and the mode of the DVD receiver do not
match, loud noise may be output from the
wireless speaker system.
7 Switch the main unit and wireless
speaker back on.
If you selected W.Stereo, start playback and
adjust the STEREO MODE VOLUME control as
necessary.
If you selected W.Surr. continue to the next
step.
WIRELESS (SHIFT+ROOM SETUP)
8 Press
repeatedly
to select a wireless listening
mode.
Choose between the following options:
04
Wireless
speaker
Listening position
(sub room)
41
En