Error Messages; Troubleshooting - Panasonic KX-TG8070FX Operating Instructions Manual

TG8070-8090FX(e-e).book Page 31 Wednesday, August 1, 2007 9:26 AM

Error messages

Error message
*1
Answer Sys. Full
Busy
No Base Found
SMS Full
SMS Transf.Fail.
Wrong PIN!
*1 KX-TG8090
Status messages
Status message
*1
-Answering-
*1
TAM Consulting
*1 KX-TG8090

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit AC
adaptor and remove the handset batteries. Then reconnect the base unit AC adaptor and install the
batteries.
Telephone
Problem
w is flashing and "Register!" is
shown on the handset display.
Cause & solution
L Erase unnecessary messages (page 24).
L Intercom call failed (the other handset cannot be found or
is on an outside call). Try again later.
L Another handset is being used. Try again later.
L Cancelling a handset failed. Try again (page 27).
L Handset registration failed (page 27). Try again.
L Erase unnecessary messages (page 21, 22).
L The message failed to be sent. Try again (page 21).
L Insert the correct base unit PIN. If you forget your base
unit PIN, consult your nearest Panasonic service centre.
L You entered the wrong remote access code in step 5,
"Turning remote operation on", page 25. Try again.
Meaning
L The unit answers a call, callers are greeted by a greeting
messages.
L The answering system is being used remotely.
L The base unit or other handset(s) are operating the
answering system.
L The answering system is being used remotely.
Cause & solution
L The handset is cancelled. If you want to register the
handset to the base unit(s), follow "Registering a handset
to a base unit", page 27. If you want to use a base unit(s)
which was registered to the handset before cancellation,
select it by following "Selecting a base unit", page 27.
Useful Information
31