Remote Operation - Panasonic KX-TG8070FX Operating Instructions Manual

TG8070-8090FX(e-e).book Page 25 Wednesday, August 1, 2007 9:26 AM

Remote operation

Using a touch-tone phone, you can call your phone
number from outside and access the unit to listen
to messages or change answering system
settings.
Important:
L In order to operate the answering system
remotely, you must first turn on remote operation
by setting a remote access code. This code
must be entered each time you operate the
answering system remotely.
Turning remote operation on
A 4-digit remote access code must be entered
when operating the answering system remotely.
The remote access code is pre-programmed in
this unit. This code prevents unauthorised parties
from listening to your messages remotely. Remote
access is not possible unless you change the
default remote access code (page 25).
1
{MENU} (right soft key) i s i {OK}
2
{^}/{V}: "Settings" i {OK}
3
{^}/{V}: "Remote Code" i {OK}
4
Enter the new 4-digit remote access code. i
{OK}
5
Enter the new 4-digit remote access code
again. i {OK} i {i}
Using the answering system
remotely
When the answering system is on
1
Dial your phone number from a touch-tone
phone.
2
Press {*} after you hear the greeting.
L The greeting will stop.
3
Enter the remote access code.
L New messages will be played back first.
L If there are no new messages, all old
messages will be played back after a long
beep.
L If you enter the wrong remote access code,
a long beep will ring 2 times. If you enter the
wrong one 2 times, it will automatically hang
up.
Answering System Features
s
4
Refer to following table and press the
corresponding keys for operations.
Note:
L You can hang up at any time.
Remote commands
Key Operation
Repeat message
{4}
(during playback)
Start and stop message playback
{5}
Skip message
{6}
(during playback)
Turn answering system on
{8}
Turn answering system off
{0}
Erase currently playing message
{#}
*1 Press again quickly to play the previous
message.
When the answering system is off
1
Dial your phone number from a touch-tone
phone.
2
Let the phone ring 10 times.
3
Enter your remote access code within 10
seconds.
L You can hang up, or enter your remote
access code again and begin remote
operation.
L If you enter the wrong remote access code,
a long beep will ring 2 times. If you enter the
wrong one 2 times, it will automatically hang
up.
*1
25