Philips Fax Machine User Manual page 13

1
1. Open the ink film cover by
pressing the blue release levers
back with both hands.
2. Then carefully fold the ink film
cover back.
If, on replacing the ink film, you notice that the colour of the grey printer roller has discoloured to
black, you must clean the roller (see chapter 7 Troubleshooting/Care and maintenance
instructions).
1. Carefully remove the fixing strips
from the new ink film. The ink film
must not be damaged.
6. Close the ink film cover by folding it forwards. Make
sure that both release levers are engaged.
Removing the old ink film
2
4
1
3. Press the empty roll of ink film on
the left-hand side against the
spring.
4. Lift the roll upwards on the left
side in order to lift it out of its seat.
Loading the new ink film
3
2. Hold the ink film so that the large
roll is underneath and the blue
gear wheel of the small roll is on
the right. Lay the ink film in the
rear ink film compartment by
pressing the right-hand blue end
of the large roll against the blue
spring shaft.
3. Then fit the left-hand black end of
the large roll on to the left-hand
shaft.
– 11 –
3
5. Remove both ink film rolls. They
cannot be reused. Dispose of the
ink film rolls with normal waste.
Load a new ink film, because your
fax machine cannot work correctly
without it.
2
4. Now take the small roll and lay it in
the grooves provided in the front
ink film compartment.
5. Turn the gearwheel of the small
roll back to tension it. Make sure
that the film is not creased.
7. Then close the operation panel.
A silver strip is fixed to the start of the ink
film, so the quality of the first few pages
may be impaired.
4
5