Panasonic Viera TX-L32DT35E Operating Instructions Manual page 40

Menu Item
HDMI1 / 2 / 3 / 4 Input
SPDIF Delay
Reset to Defaults
Timer Programming
Off Timer
Auto Standby
Eco Navigation
Recording Setup
VIERA Link
HDMI Content Type
AV1 out
Power on Link
Power off Link
40
Adjustments / Configurations (alternatives)
Select to fit the input signal [Digital] / [Analogue] (p. 115)
[Digital] : HDMI cable connection
[Analogue] : HDMI-DVI adaptor cable connection
•
HDMI input mode only
Adjusts the delay time of the sound output from DIGITAL AUDIO OUT and HDMI2 (ARC
function) terminals if the sound does not synchronize the image
•
DVB mode only
Press the OK button to reset the present Sound Mode, [Balance], [Headphone Volume]
and [Surround] to the default settings
Sets a timer to remind watching or record forthcoming programmes (p. 56)
•
DVB mode only
Sets the time until the TV automatically goes to Standby mode
[Off] / [15] / [30] / [45] / [60] / [75] / [90] (minutes) (p. 20)
Sets the time the TV automatically goes to Standby mode when no operation is
performed for the selected times [Off] / [2] / [4] (hours)
•
Starting Timer Programming automatically does not affect this function.
•
Automatic input switching with the connected equipment affects this function and
time-count will be reset.
•
The notification message will appear 3 minutes before going to Standby mode.
Automatically sets the TV to the most suitable energy-saving mode
•
If you press the OK button, the following items are set as below :
[Eco Mode], [VIERA Link], [Power off Link], [Standby Power Save], [Power Save]
[Intelligent Auto Standby]
[Auto Standby] [2 hours]
Formats the connected USB HDD and sets the condition (p. 71)
Sets to use VIERA Link functions [Off] / [On] (p. 102)
Adjusts the picture settings according to the content type signal from the connected
equipment via HDMI cable [Off] / [Auto]
•
This function is available if the connected equipment supports HDMI Content Type.
•
The content type information will be displayed for several seconds when this function
works.
Chooses the signal to be transmitted from the TV to Q-Link [TV] / [AV2] / [Monitor]
[Monitor] : Image displayed on screen
•
Component, PC and HDMI signals cannot be output.
Sets to use Power on Link function [Off] / [On] (p. 101, 102)
Sets to use Power off Link function [Off] / [On] (p. 101, 102)
[On (No reminder)]
[On]