Messages - Panasonic SC-BTT100 Operating Instructions Manual

Radio
Distorted sound or noise is heard.
Adjust the position of the antenna.
A beat sound is heard.
Try to keep a certain amount of distance
between the antenna and the TV.
Noise is excessive.
Change the audio to be output as monaural.
Press [AUDIO] to select "MONO".
The sound becomes monaural.
≥ To cancel, press the button again or change
the frequency.
In normal circumstances, select "AUTO STEREO".
Network
I can't connect to the network.
Confirm the network connection and settings.
( 14, 15, 34)
There may be obstacles that prevent the unit
from detecting your home network. Bring the
unit and the wireless router closer to each
other.
Check the operating instructions for each
device and connect accordingly.
When using wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
Higher transfer rate router such as 802.11n
(2.4 GHz) wireless router may solve the
problem. If you use 802.11n (2.4 GHz)
wireless router, it is necessary to set the
encryption type to "AES".
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
On the "Wireless Settings" screen (
continuous lighting of at least 4 "Reception"
indicators is the target for a stable connection.
If 3 or fewer indicators are lit or the
connection is being interrupted, change the
position or angle of your wireless router and
see if the connection state improves. If there
is no improvement, connect to a wired
network and perform the "Easy Network
Setting" ( 15) again.
42
VQT4R78

Messages

The following messages or service numbers may
appear on the TV or unit's display.
On the television
Cannot play.
You inserted an incompatible disc.
Cannot play on this unit.
You tried to play a non-compatible image.
Confirm "SD" on the unit's display is not
displayed and re-insert the card.
No disc inserted.
The disc may be upside down.
$ This operation is not available.
Some operations are unsupported by the unit.
(For example, reverse slow-motion, etc.)
IP address is not set.
The "IP Address" in "IP Address / DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Gateway
Address". (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
Set a stronger network security level referring
to the wireless router operating instructions.
34), the