Sequential Play - Panasonic SL-CT790 Operating Instructions Manual

Portable cd player sl-ct790
Table of Contents

Advertisement

Sequential Play

1
OPEN
Label must face
upward.
near the center so
the
disc
firmly into place.
Close the lid.
5
VOL
Decrease
Follow steps 1–5.
In step 2: Connect the stereo earphones and wired re-
mote control to the headphone jack [Ë].
(Plug in firmly.)
In step 5: ≥The volume range is 0-25. (Press and hold
to change the volume successively.)
In step 5:
≥The volume changes when pressed while
the level is displayed. If any other display is
shown, it changes to show the current level.
(The volume returns to 10 when you dis-
connect the power source.)
In step 5:
≥If you have connected a cable to the [OPT
OUT/OUT] jack, you cannot change the vol-
ume and sound will not be output through
the headphones. An error tone (beep-beep-
beep-beep) sounds when you press [i] or
[j] of the remote control.
Note!
≥Play stops automatically when all the tracks have
been played.
≥If the unit has been connected to the car audio sys-
tem, set this unit's volume to 10, then adjust the vol-
ume level on the system.
Auto-off function
If you leave the unit in stop mode for about 10 minutes,
(30 seconds if a disc is not loaded) it turns off to save
4
the memories.
Basic Play
O P E
N
Press
C H G
clicks
Plug type:
3.5 mm stereo
Remote control
(Beep)
MODE
MEMORY
Increase
(Beep)
VOL
S-XBS
Resume function
The player stores the track where you stopped play and if
you press [1/;] (main unit) or [1/∫] (remote control),
play resumes from the beginning of that track.
Note!
≥Opening the lid while in the stop mode or replacing
the disc while in the off mode cancels the function. (It
may remain active if you replace a disc in the off
mode.)
≥Play may resume from the beginning of the next track
if you stopped play near the end of a track.
≥The resume function is automatic and you cannot turn
it off.
For your reference:
"
" indication
)
This indication appears for about 30 seconds if [1/;]
(main unit) or [1/∫] (remote control) is pressed when
no disc is loaded in the unit or if the disc is not properly
secured.
"*" indication
This indication appears for about 10 minutes when the
lid is opened. (However, the indication does not appear
when the unit is powered off.)
2
R
EQ
MODE
MEMORY
VOL
4
Increase
Decrease
L
3
HOLD
Remote control
HOLD
Remote control
MODE
MEMORY
Track number in play
S-XBS
Elapsed playing time of each track
Removing discs
1 Press [∫] to stop play and disc rotation.
2 Slide [OPEN] to open the lid.
3 Once the disc has stopped, lift the disc
out with your finger in the depression.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Depression
Note!
Never insert foreign objects into the unit.
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
Finalizing is a process that enables CD-R/CD-RW players
§
to play audio CD-R and CD-RW.
HOLD
(Beep)
upon completion
§

Advertisement

Table of Contents
loading

Table of Contents