Table of Contents
Advertisement
1 Slide [OPEN] to open the lid, and in¬
sert the disc.
® Label must face upward.
Press the area near the center hole of the disc
until it clicks into position.
© Close the lid.
2 Release the hold mode.
3 Set play mode selector to [NORMAL].
4 Connect the wired remote control and
the stereo earphones to the [ft] jack.
(Plug in firmly.)
5 Press [►II].
Play now starts.
© Track number in play
@ Elapsed playing time of each track
Play stops automatically when all the tracks have
been played.
6 Adjust the volume level.
(If the unit has been connected to the car audio sys¬
tem, adjust the volume level between 4 and 6 on the
unit, then adjust the volume level on the system.)
For your reference:
"no dlSC'
indication
This indication appears for about 30 seconds if [► 11] is
pressed when no disc is loaded in the unit or if the disc is
not completely seated.
"QPtfl"
indication
This indication appears for about 10 minutes when the
cover is opened. (However, the indication does not ap¬
pear when the unit is powered off.)
Auto power off function
If the unit is left in stop or paused status for approxi¬
mately 10 minutes, the unit powers itself off automat¬
ically in order to prevent the battery from running
down.
(If no disc is loaded in the unit, it powers itself off in
about 30 seconds.)
Advertisement
Table of Contents
